9 10
2）Indicator light
1、White LED 1 flashing, charging/undervoltage
2、If the White LED1 is always on and LED2 light
flashes, it indicates charging
3、If the White LED1 and LED2 are always on
and LED3 light flashes, it indicates charging
4、If the White LED1, LED2 and LED3 are always on,
it indicates full power
1）As shown in the figure, press the bottom cover button of the dust cup, and the bottom
cover is suspended to expose the cyclone cone
Using method
LED3
LED2
LED1
.Battery replacementⅥ
Ⅶ .Dust bucket cleaning method
Press the battery release button
Dust cup bottom
cover button
Cyclone cone
Pull out batter y to
the right
Insert the batter y
to the left
Using method
1) When there is only one cell left in the power indicator, it indicates that the machine
is low in power and needs to be charged. When charging, after hanging the machine to
the charging bracket, connect the charger to the machine. The White light flashes on the
machine, indicating that it is charging.
Warm prompt: There are two ways to use the hanger:
① Use expansion screws to hang the vacuum cleaner on the wall.
② 4*3M glues are attached to the back of the hanger. The position of the hanger against
the wall is the same as that of the vacuum cleaner, and the auxiliary vacuum cleaner is
stored vertically (cannot be hung).
V .Charging method
Charging indicator
light
Charging inlet
4、Attach onto the aluminium tube following instructions on page 4.
To Next Page
Loading...
