12
Using method
6）Install the HEPA according to the direction shown in the figure
7）Install the cyclone cone in the direction shown in the figure
8）Rotate the bottom cover of the dust bucket as shown in the figure, and hear a "click" to
indicate that it is in place
11
2） As shown in the figure, rotate the cyclone cone, and then pull it down to take out the
cyclone cone
3）As shown in the figure, rotate the HEPA, and then pull it upwards to take out it
4） The HEPA and cyclone cone can be cleaned with water
5）After cleaning, be sure to dry the HEPA and the cyclone cone
Using method
24
hrs
12
6
11
10 2
8 4
9 3
1
11
1
To Next Page
Loading...
