Sharp EC-SC95U-H - Use of Mite-Removing Brush; Setting up the Water Tank

7 8
b）Remove the roller brush rod
As shown in the figure, rotate the ON/OFF to unlock, and then pull out the roller brush
rod.
2、As shown in the figure, turn the brush head to the front, and then insert the long flat
nozzle into the main body
1、 Insert the mite-removing nozzle directly into the main body interface
2、Clean the mite-removing nozzle
a） Clean with a cleaning brush
Using method Using method
Ⅲ．Use of mite-removing brush
Use a blade to cut off the
hair and other garbage
wra pped arou n d th e
roller brush rod.
Clean up the cut- off
garbage with harrow.
Use a brush to clean up
dust and othe r small
particulate garbage.
Cut-off
Harrow Cleaning
Ⅳ:Setting up the water tank
1、Fix the mop pad included with the water tank onto the head by
pressing on the fastening tape.
2、Open the plug to fill the tank with tap water.
3、Fasten the water tank to the floor brush as shown in the figure.The Water tank is
attached to the floor brush by magnet and you will notice a click when securely fastened.
Water tank plug
Notice;