Sharp ER-A250

When
printing
becomes
faded,
replace
the ink
roller
with
a new
one
specified
by
Sharp.
Replacement
1. Pull
the
rear
of the
printer
cover
upward
and
detach
it.
2. Locate
the ink
roller
in
front
of the
printer
and remove
it by
pulling
its
handle.
3. Installa
new
ink
roller.
4.
Replace
the
printer
cover.
|,.--;*,?
'
Be
sure
to
use an ink
roller
specified
by
Sharp.
Use
of any
other ink
roller
could
vquuurri
cause
the
printer
to malfuction.
.
Installthe
ink
roller
immediately
after
unpacking.
Do
not
allow
it
to
get
dirty.
.
Do
not
add ink
to
the ink
roller.
'
Use
a new
ink roller
as soon
as
possible.
lf
stored
for
a long
time
the
ink
will
dry
and life
will
be shortened.
lf
you
must
store
it,
keep
it in
an
iirtignt
container
in
i
cool,
dark
place.
Do
not
expose
it to
high
humidity
or direct
suntight.
When
logo
printing
becomes
faded,
it is
time to
refillthe
ink.
1.
Pull
the rear
of the
printer
cover
upward
and
detach
it.
2. While
lifting
the
receipt
paper
roll,
reach
behind
the
printer
and
pull
out the logo
stamp,
using
its
handle.
3. Locate
the two
ink
holes
behind the
logo
stamp
and
add
a few
drops
of ink
to each
one.
4.
Replace
the
logo
stamp.
5. Replace
the
printer
cover.
.
when
the
supplied
ink
runs
out, contact your
dealer
for the
specified
logo
ink.
.
Try
to refillthe
logo
stamp
six to
ten hours
before
use.
/l\
.,
E*h,
'
Never
apply
the ink
to the
ink roller.
This
may
cause
damage
to
the
printer.
49
www.cashregisters.net