ER-A410/ER-A420 PROGRAM (PGM2/PGM1) MODE
2 – 23
* EFT FUNCTION always uses RS port 2.
*DATA BACK UP FUNCTION always uses RS port 1.
[JOB#2711]
TAX RATE PROGRAMMING
(LOWER TAX LIMIT is invalid in VAT system.)
MRS = DELETE
[JOB#2900]
<CAUTION>
(This JOB must be performed at X2/Z2 mode position.)
AUTO KEY SETTING
(Auto key function)
• This machine has [AUTO] key which can be programmed by the fol-
lowing key-sequence.
• When [AUTO] key is depressed, the machine works the same as the
programmed key-sequence programed.
<Example>
(X2/Z2)
(REG)
(X2/Z2)
(REG)
X: 2 Not used (Fixed at “0000“) MRS = 0000
X: 3 MRS = 0000
A: Not used (Fixed at “0”)
B: Channel No. for slip printer B
Not connect 0
RS port 1 1
RS port 2 2
C, D: Not used (Fixed at “00”)
(Note: When the ER-03EF is connected, RS port 2 cannot be used
for other purposes.)
(Note: If RS port 1 is not used by DATA BACKUP FUNCTION, it is
available for other purposes by setup.)
A: TAX 1 PROGRAMMING = 1
TAX 2 PROGRAMMING = 2
TAX 3 PROGRAMMING = 3
TAX 4 PROGRAMMING = 4
X: SIGN X
+0
-1
YYY. YYY: RATE = 0.0000 to 100.0000 %
ZZZZZ: LOWER TAX LIMIT = 0 to 99999
2711
XYYY.YYYY
A
TAX No.
TL
ST
TL
ST
TL
ST
Sign & TAX rate
0
ZZZZZ
Lower TAX limit
for ADD-ON TAX
0
Delete
Delete
Delete
(Rate = 0%,
Lower TAX limit = 0)
(Lower TAX limit = 0)
2900 (Free key)
AUTO
Max.25
TL
AUTO2
AUTO3
AUTO4
AUTO5
AUTO
AUTO2
AUTO3
AUTO4
AUTO5
Delete
AUTO10
AUTO10
2900 AUTO PLU1
100
DEPT2 AUTO
TL
Key entry R/J Display Comment
AUTO PL000001 *1.10
DEPT02 *1.00
PL0000001 same as entryPLU1
1.10
1
10
100
DEPT02
1.10
same as entry1
same as entry0
same as entry0
same as entryDEPT2
2900 AUTO2
100
AUTO2 TLTL
Key entry R/J Display Comment
DEPT 1 DEPT01 DEPT01
1.00
100
CHANGE
0.00
same as entry1
same as entry0
same as entry0
same as entryTL
AUTO 2
*1.00
***TOTAL *1.00
C
ASH *1.00
CHANGE *0.00
10
1
To Next Page
Loading...
