Sharp ER-A410 - Page 39

ER-A410/ER-A420 PROGRAM (PGM2/PGM1) MODE
2 – 24
[JOB#2990]
THERMAL PRINTER PROGRAMMING
MRS = 50
[JOB#6110]
RS-232C TERMINAL No.
XXXXXX: Terminal number
MRS = 000001
[JOB#6111]
RS-232C TRANSMISSION
MRS = 00
[JOB#6112]
RS-232C FUNCTION SELECTING
(*) Data value “3/2/1/0” is reserved.
Note: The value of baud rate is used at Online communication and
Print data function.
It is not used at Data back up function (SRV#996, SRV#998).
MRS = 06
[JOB#6113]
RS-232C PROGRAMMING
XXX: Start code (000-127)
YYY: End code (000-127)
MRS = 002013
[JOB#6115]
RS-232C TIME OUT
XXX: Time out time (1-255 sec)
MRS = 007
[JOB#6220]
PRINT DATA SENDING
MRS = 000
ZZ: Selecting of light and shade ZZ
Lighter than standard 00
Standard (90% for printer standard) 50
Darker than standard 99
A: Sending of CI signal A
No 0
Yes 1
B: Transmission line form B
Full duplex system 0
Half duplex system 1
A: Print data A
Data download and upload 0
Print data send 1
B: RS-232C Baud rate B
4800bps 4
9600bps 5
19200bps 6
38400bps 7
0
2990 ZZ TL
6110 XXXXXX
0
TL
6111 AB
0
TL
6112 AB
0
TL
A: Sending of DR signal A
Yes 0
No 1
B: Sending of CS signal B
Yes 0
No 1
C: Sending of all print data C
Disable 0
Enable 1
6113 XXXYYY
0
TL
6115 XXX
TL
6220 ABC
0
TL