Sharp ER-A450T - Page 7

ER-A450T Setup
Page / 6
Designs and specifications are subject to change without notice.
PREPARING THE ER-A450T
1. SRV Mode Related Jobs:
The presets for SRV job #912 may be changed for ER-A450T by following these steps;
(1) Place the SRV key to the SRV mode (Fig. 4).
(2) Changing SRV job #912:
The ER-A450T Header and Footer print controls are located in the SRV job #912.
xx = (see chart below)
X2/Z2
X1/Z1
MGR
REG
OP,X/Z
PGM1
OFF
PGM2
(SRV)
(SRV')
OP
SM
MA
SRV
912
.
444
@/
FOR
0 0 x x
4
CA/AT
(FIG.4)
219#boJVRS
noitpircseD ataD
SRM
stluafeD
A
---- --
0
---- --
:tamroFtnirPetaD YY-DD-MM/YY-MM-DD/DD-MM-YY0/1/2
^......snoitceleSfoMUS
B
---- --
0
---- --
:metsySemiTmetsySruoH-21/metsySruoH-420/1
^....snoitceleSfoMUS
C
:tpieceRnoitcasnarTretfAylnOslatoT/sliateD0/4
6
:noitcnuFtpieceRypoCoN/seY0/2
:lortnoCtnirPretooF stpieceRllA/syeKaideMdetceleSyB0/1
^....snoitceleSfoMUS
D
:lortnoCegasseMogoLredaeHeniL-30
0
ylnoogoLscihparG1
retooFeniL-3dnaogoLscihparG2
redaeHeniL-63
redaeHeniL-3dnaogoLscihparG4
retooFeniL-3dnaredaeHeniL-35
^....snoitceleSfoMUS