Sharp ER-A450T - Page 8

ER-A450T Setup
Page / 7
Designs and specifications are subject to change without notice.
2. The ER-A450T SIO Function:
In addition to setting the graphics logo print control, the image data may be sent to the ER-A450T
using the SIO Function.
(1) Connection at the ER-A450T;
The Program Back up/Restore (SIO) function has been fixed to port-2 (Channel #1) of the
ER-A450T as shown below:
(FIG.5)
Channel No.:
Port 1(CH8)
Channel No.:
Port 2(CH1)
3
When using the SIO
function, the connection
for the cable is port-2
(CH#1)
X
998
.
444
@/
FOR
4
CA/AT
SBTL (Auto baud rate detection - SRV job#903-A)
(2) Placing the ER-A450T into the Receive State;