Sharp ES-NFA714BWB-DE

Questions and Answers

R
russoandrewAug 16, 2025
Why won't my Sharp ES-NFA714BWB-DE Washer start?
- T
  Theresa WallaceAug 17, 2025
  If your Sharp Washer doesn't start, several factors could be at play. Ensure the machine is properly plugged in and that the fuses are in good working order; replace them if necessary. Verify that there is a stable mains power supply. Don't forget to press the Start/Pause button and confirm that the program dial is set to your desired position. Finally, make sure the machine door is fully closed.
R
rachelenglishAug 19, 2025
What to do if my Sharp ES-NFA714BWB-DE does not discharge water?
- M
  Marissa HallAug 19, 2025
  If your Sharp Washer isn't draining water, the drain hose might be clogged or twisted; inspect it, and either clean or untwist it. Another potential issue is a clogged pump filter, which should be cleaned. Also, if the laundry is too tightly packed in the drum, redistribute it evenly.
M
Michael MannAug 22, 2025
Why is the spin cycle delayed on my Sharp ES-NFA714BWB-DE Washer?
- J
  James MartinezAug 22, 2025
  If the spin cycle on your Sharp Washer is delayed or doesn't occur, it might be because the Unbalanced load control system has been activated. This is not a fault. The system is attempting to redistribute your laundry. Once the load is balanced, the spin cycle will commence. For future washes, load the drum evenly.
D
David MillerAug 25, 2025
How to stop my Sharp ES-NFA714BWB-DE from vibrating?
- K
  khanchristopherAug 26, 2025
  If your Sharp Washer vibrates excessively, it might be due to several reasons. Check if the feet of the machine have been properly adjusted. Ensure that the transit bolts, used for transportation, have been removed. Avoid placing the machine on a hard surface. If you've overloaded the machine or the laundry is unevenly spread, redistribute the load evenly. Note that a small load can also cause vibration, but this will not prevent the operation of your machine.
M
Morgan FisherAug 27, 2025
Why is my Sharp Washer not cleaning clothes properly?
- D
  Danny NunezAug 27, 2025
  If you're not satisfied with the washing results from your Sharp Washer, consider whether your laundry is too dirty for the selected program. Refer to the program tables to choose a more suitable program. Also, ensure you're using enough detergent as instructed on the packaging, and that you're not overloading the machine beyond the maximum capacity for the selected program.
L
Leonard HoodAug 30, 2025
Why is my Sharp Washer not taking in water?
- A
  Andrew Doyle DDSAug 30, 2025
  If your Sharp Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist if necessary. Also, the water inlet hose or inlet filter may be clogged, so clean these filters. Lastly, ensure that the machine door is completely closed.
T
Travis LucasSep 2, 2025
How to reduce foam in my Sharp Washer detergent drawer?
- W
  williamyoungSep 2, 2025
  If you notice excessive foam in the detergent drawer of your Sharp Washer, it's likely due to using too much detergent or using the wrong type. To stop the foam, press the Start/Pause button, then dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button again after 5-10 minutes. Ensure you only use detergents specifically produced for automatic Washing Machines.
Y
Yvette SandersSep 4, 2025
What to do if my Sharp Washer is not cleaning well in hard water?
- R
  Ryan SimmonsSep 4, 2025
  If you're experiencing unsatisfactory washing results with your Sharp Washer, especially in areas with hard water, try increasing the amount of detergent according to the manufacturer’s instructions. Also, make sure your laundry is spread out in the drum.
A
Allen AlexanderSep 7, 2025
Why does my Sharp Washer discharge water immediately after loading?
- G
  greedSep 7, 2025
  If your Sharp Washer immediately discharges water as soon as it's loaded, the end of the water drain hose might be positioned too low. Check that the drain hose is at a suitable height.
F
fredericklucasSep 10, 2025
How to remove detergent residue from laundry after using my Sharp ES-NFA714BWB-DE?
- R
  rwashingtonSep 12, 2025
  If your laundry has detergent residue after washing in your Sharp Washer, it may be due to non-dissolving particles in some detergents appearing as white spots. You can perform an extra rinse or clean your laundry with a brush after it dries.

Summary

Safety Instructions

General Safety Warnings

Covers appliance operation, environment, children, electrical hazards, fire risks, and general usage precautions.

During Use

Guidance on operating the machine, handling packaging, installation, and use by children.

Packaging and Environment

Details on removing packaging materials and their environmental benefits.

Savings Information

Tips for efficient use to save energy and water.

Technical Specifications

Lists key technical data: voltage, current, water pressure, power, capacity, spinning speed, and dimensions.

Installation

Removing Transit Bolts

Instructions for removing transit bolts and rubber spacers before machine operation.

Adjusting Feet

Guidance on leveling the machine using adjustable feet for stable operation.

Electrical Connection

Details on the required power supply and safe electrical connection procedures.

Water Inlet Hose Connection

Instructions for connecting the water inlet hose to the machine and water supply.

Water Discharge Connection

Steps for correctly connecting the water drain hose to a standpipe or sink.

Control Panel Overview

Detergent Drawer

Identifies compartments for detergents and softeners within the detergent drawer.

Sections

Explains the purpose of each detergent drawer compartment for different wash needs.

Program Dial

Describes how to select washing programmes using the program dial.

Electronic Display

Explains indicators and information shown on the electronic display panel.

Using Your Washing Machine

Preparing Your Laundry

Guidance on sorting laundry, checking pockets, and preparing garments for washing.

Loading Laundry

Instructions on opening the door and loading laundry evenly into the drum.

Adding Detergent

How to add the correct detergent amount based on laundry type and water hardness.

Operating Your Machine

Steps for plugging in, turning on water, and starting the washing cycle.

Selecting a Programme

How to choose the most suitable washing programme for your laundry.

Half-Load Detection

Explains the automatic half-load function for saving water and energy.

Additional Functions

Details on using extra features like temperature selection, spin speed, and delay timer.

Child Lock

Instructions on activating and deactivating the child lock feature to prevent unintended changes.

Cancelling Programme

Steps to cancel a running washing programme at any time.

Programme End

What happens when a washing programme finishes and post-wash actions.

Programme Table

Programme Table Information

Notes on programme duration, temperature defaults, rapid wash, and eco-programme definitions.

Cleaning and Maintenance

Cleaning and Maintenance Warning

Safety precautions before maintenance: unplugging, turning off water, and cleaning agents.

Water Inlet Filters

Instructions for cleaning water inlet filters to ensure proper water intake.

Pump Filter

Steps for cleaning the pump filter to maintain pump longevity.

Detergent Drawer Cleaning

Guidance on removing and cleaning the detergent drawer to prevent residue buildup.

Body and Drum Cleaning

Troubleshooting

Fault Warnings and Actions