Polling
166
1 Load the document.
2 Make sure the reception mode is set to AUTO (see page 67).
3 Press and then or
until MEMORY POLL MODE is selected
in the display.
4 Press .
5 Make sure that “SET” is selected in the
display and then press .
6 If no other memory polling documents have been stored, select “1
TIME” to allow polling only once, or “REPEAT” to allow polling an
MENU
START/
ENTER
START/
ENTER
Display:
MENU MODE
4:OPTIONAL SETTING
5:PROGRAM/GROUP MODE
6:SERIAL POLLING MODE
7:MEMORY POLL MODE
MEMORY POLLED SET
1=1 TIME
2=REPEAT
Display when no other memory
polling documents are stored:
MEMORY POLLED SET
1=APPEND
2=CANCEL
Display when another document
is already stored:
MEMORY POLLED MODE
1=SET
2=CLEAR
To Next Page
Loading...
