Setting the Date and Time
27
1. Installation
Setting the Date and Time
The date and time appear in the display, in reports, and at the top of each
page you transmit. Set the date and time by pressing the keys on the
operation panel as shown below.
1 Press and then or
until ENTRY MODE is selected in the
display.
2 Press and then or
until DATE&TIME SET is selected.
3 Press .
4 Enter a two-digit number for the month (“01” for January, “02” for
February, “12” for December, etc.).
Example: March
• To correct a mistake, press to move the cursor back to the mistake and
then enter the correct number.
5 Enter a two-digit number for the day (“01” to “31”).
Example: The 5th
MENU
START/
ENTER
START/
ENTER
0
3
0
5
The currently
set date and
time appear
ENTRY MODE
01:DESTINATION SETTING
02:PASSCODE SETTING
03:OWN PASSCODE SET
04:DATE&TIME SET
Display:
MENU MODE
1:RECEIVE MODE
2:LISTING MODE
3:ENTRY MODE
DATE&TIME SET MODE
01-10-2006
TIME 11:35 AM
To Next Page
Loading...
