Sharp FO-DC535 - Page 205

Optional Settings
203
7. Optional
Settings
Setting 05: TRANSACTION REPORT PRINT SELECTION
This sets the condition for printing out a Transaction Report. Press or
to select one of the following conditions, and then press
♦ Initial setting: ERROR ONLY
Setting 06: RECALL TIMES
This sets the maximum number of times your fax will automatically redial if the
line is busy. Enter any number from to .
♦ Initial setting: 02
Setting 07: RECALL INTERVAL
This sets the amount of time your fax will wait between automatic redials
when the line is busy. Enter for 1 minute, for 2 minutes, etc.,
up to a maximum of 15 minutes.
♦ Initial setting: 05
Setting 08: SECURITY SELECTION
Select ON to turn polling security on, or OFF to turn it off. Press or
to make the selection and then press .
♦ Initial setting: ON
ERROR/TIMER/
MEMORY:
A report will be printed after an error, timer
operation, or memory operation
SEND ONLY A report will be printed only after a
transmission
ALWAYS PRINTS A report will be printed after each
transmission, reception, or error
NEVER PRINTS A report will never be printed.
ERROR ONLY A report will be printed only after an error
occurs
START/
ENTER
0 0
1
4
0
1
0
2
START/
ENTER