11
FV-DB1E
04/4/12 FV-DB1E_2.fm
TINSEA025SJZZ
DAB (Digital Audio Broadcasting) Operation
Various settings
! Changing the station order
You can change the order of stations in the station list.
! Adjusting the DRC value
When the volume is low, adjust the DRC (Dynamic Range Control)
value to make the sound more audible (may not available for some
broadcast material).
1 Press the BAND button until "DAB" ap-
pears on the display.
2 Press the MENU button repeatedly to
select "Station order".
3 Within 30 seconds, press the ENTER
button.
4 Within 30 seconds, press the TUNING ( or ) button to
select the desired station order.
Alphanumeric:
All stations are displayed in alphanumeric order. This is the de-
fault setting.
Fav. station:
The 10 most recent stations appear as "Fav." and then appear
in alphanumeric order.
Active station:
The station list shows receivable stations and then others in al-
phanumeric order.
Multiplex:
Stations are sorted by frequency, in ascending order.
Trim stn. list:
Delete inactive stations from the list.
5 Within 30 seconds, press the ENTER
button.
1 Press the BAND button until "DAB" appears on the display.
2 Press the MENU button repeatedly to
select "Set DRC Value".
3 Within 30 seconds, press the ENTER
button.
4 Within 30 seconds, press the TUNING
( or ) button to select the desired
DRC value.
DRC 1: Dynamic range is controlled as set for the broad-
cast. This is the default setting.
DRC 0: DRC is off.
DRC 1/2: Dynamic range is controlled half as much as the
level set for the broadcast.
5 Within 30 seconds, press the ENTER
button.
3
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
