8
4. Press the +/– button to adjust the
volume to your desired level.
TIP:
While in HDMI ARC/OPTICAL mode, if
there’s no sound output from the unit,
you may need to activate PCM signal
output on your source device (eg. TV, DVD
or Blu-ray player).
Bluetooth Operation
Pair Bluetooth-enabled Devices
The rst time you connect your Bluetooth
device to this player, you need to pair
your device to this player.
NOTE:
The operational range between this
player and a Bluetooth device is
approximately 8 meters (without any
object between the Bluetooth device
and the unit).
Before you connect a Bluetooth device
to this unit, ensure you know the
device’s capabilities.
Compatibility with all Bluetooth de-
vices is not guaranteed.
Any obstacle between this unit and
a Bluetooth device can reduce the
operational range.
If the signal strength is weak, your
Bluetooth receiver may disconnect,
but it will re-enter pairing mode
automatically.
1. Turn on the soundbar by pressing the
standby button.
2. Press the
button on the unit
repeatedly or
button on the remote
control to select Bluetooth mode. You
are in bluetooth mode when you see
letters „bt“ ashing on the display.
3. Enter the Bluetooth search mode on
the device you wish to connect to the
soundbar.
4. Select SHARP HT-SB150 from the list.
5. Your device and the soundbar will
now be connected.
– To disconnect your device, switch o
the Bluetooth connection or hold down
button on the remote control for 3
seconds.
TIPS:
• Enter „0000“ for the password if
necessary.
• The player will also be disconnected
when your device is moved beyond the
operational range.
• If you want to reconnect your device
to this player, place it within the opera-
tional range.
• If the device is moved beyond the
operational range, when it is brought
back, please check if the device is still
connected to the player.
• If the connection is lost, follow the
instructions above to pair your device
to the player again.
Listen to Music from Bluetooth
Device
If the connected Bluetooth device
supports Advanced Audio Distribution
Pro le (A2DP), you can listen to the
music stored on the device through the
soundbar‘.
If the device also supports Audio Video
Remote Control Pro le (AVRCP), you
can use the soundbar‘s remote control
to play music stored on the device.
1. Pair your device with the player.
2. Play music via your device (if it
supports A2DP).
3. Use supplied remote control to control
play (if it supports AVRCP).
To pause/resume play, press the
button on the remote control.
To skip to a track, press the
/
buttons on the remote control.
To Next Page
Loading...
Need help?
General
