Sharp HT-SB350 - Page 12

Thevolumeismutedtemporarily_
whenpressingtheMUTEbutton i
ontheremotecontrol.Pressagak_ i [_'_ _J
torestorethevolume. _/1iililli ilil!_
Press the ON/STAND-BY button.
Thesoundmodeindicatoranddisplaylightup.
Note:
ifthe power does notturn on, check whether
the power cord is plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Press the DIMMER button to adjust the brightness
of the display and sound mode indicator.
I ound mode indicator and display bright
Sound mode indicator and display dim
Soundmode indicator anddisplay off Pressingany
buttonwill lightup thedispEayfor 3 secondsonly
Ifyou turnoff andon the unitwith thevolumeset
to40 or higher,thevolumestartsat20 andfades
intothe lastsetlevel.
Unit operation:
Pressvolumeup(VOL,+) to increasethevolume
and press volumedown (VOL - ) to decrease
thevolume,
Remotecontrol operation:
PresstheVOLUME+ buttonto increasethevolume
andtheVOLUME- buttontodecreasethevolume.
OO,,Ol_O2 ..... _59_60
Mainunit operation:
Tochange to a differentmode, press the SUR-
ROUNDbuttonrepeatedlyuntilthedesiredsound
modelightsup.
RemotecontroJoperation:
Pressadesiredsoundmodeontheremotecontrol.
f_
ST/,NDAr,D CI_E_AG_MESPOF_T_EWS I1 _1
STAN[_ARDWOWHDisonfornominaleffect
EMA,,GAMEWOWHDonforcinema/gamesoundeffect
SPORT WOWHDonforsportbroadcasting
Y
NEWS WOWHDonfornews
The DolbyVirtualSpeaker(DVS}createsvirtual
surroundscomparabletothe5.1chsoundproduced
by the2.1chspeaker.WhensettingDVSto "ON"
for 2 channelstereosignals, DolbyPro Logic [I
bringsoutvirtualsoundeffectsthroughthesignals
convertedinto5.1ch.
Pressthe DVSbutton.
TheDolbyVirtualSpeakerindicatorlightsup.
Notes:
O Monauralsignalsdo not generatesurroundef-
fects.
• DVSsoundeffectmaynotbe obtaineddepend-
ingon signaltypes(the DolbyVirtualSpeaker
indicatorblinks).Inthiscase,settheDVSmode
to"OFF".