Sharp HT-SB603 User Manual

E-4
Precautions
General
4" (10 cm)
4" (10 cm)
4" (10 cm)
Use the unit on a firm, level surface free from vibration.
4" (10 cm)
4" (10 cm)
4" (10 cm)
0" (0 cm)
4" (10 cm)
Table/floor
Keep the unit away from direct sunlight, strong
magnetic fields, excessive dust, humidity and
electronic/electrical equipment (home computers,
facsimiles, etc.) which generate electrical noise.
Do not place anything on top of the unit.
Hold the AC power plug by the head when removing
it from the AC outlet, as pulling the cord can damage
internal wires.
The AC power plug is used as a disconnect devic
e
and shall always remain readily operable.
Do not remove the outer cover, as this may result
in electric shock. Refer internal service to your
local SHARP service facility.
This unit should only be used within the range of 41°F -
95°F (5°C - 35°C).
SHARP is not responsible for damage due to improper
use. Refer all servicing to a SHARP authorised
service center.
Warnings:
The voltage used must be the same as that specified
on this unit. Using a higher voltage is dangerous and
may result in a fire or other type of accident causing
damage. SHARP will not be held responsible for any
damage resulting from such usage.
In case of repairing, please bring the entire system set
to the service center.
Volume control
The sound level at a given volume setting depends on
speaker efficiency, location and various other factors.
It is advisable to avoid exposure to high volume levels,
which occurs while turning the unit on with the volume
control setting up high, or while continually listening at
high volumes.
Controls and indicators
Sound Bar Front Panel
SOUND BAR HOME THEA TER SYSTEM HT -SB603
SOUND BAR HOME THEA TER SYSTEM HT -SB603
1
3
4 5 76 8 9
2
1. Left Channel Speakers
2. Right Channel Speakers
3. On/Standby Button
4. INPUT Button
5. Pairing Button
6. Remote Sensor
7. Sound Mode Button
8. Volume Down Button
9. Volume Up Button
Do not expose the unit to moisture, to temperatures
higher than 140°F (60°C) or to extremely low
temperatures.
If the unit does not work properly, unplug and plug it in
again. Than turn on the unit.
In case of an electrical storm, unplug the unit for
safety.
z Please ensure that the equipment is positioned in a well
ventilated area and ensure that there is a free space
along the sides, top and back of the equipment as below.
4" (10 cm)
9/16" (1.5 cm)
Wall mount
bracket
4" (10 cm)
4" (10 cm)
4" (10 cm)
Wall mount

Sharp HT-SB603 Specifications

General

Brand	Sharp
Model	HT-SB603
Category	Home Theater System
Language	English