Sharp HT-SBW260

EN
What is included in the box:
• 1x Main unit
• 1x Wireless Subwoofer
• 1x Remote control
• 1x AAA battery
• 1x User guide
• 1x Quick start guide
• 1x Power Adapter
• 2x UK power cord
• 2x EU power cord
• 1x Wall-mounting installation set
Controls
1 2 3 4
1. Standby button – Switch the unit between ON and STANDBY
mode.
2.
Source button – Select the play function.
3.
Bluetooth button – Select the Bluetooth mode.
4. Volume +/- button – Increase/decrease the volume level.
Inputs/Outputs
1 2 3 4 5 6
LINE IN
HDMI OUT (ARC)
H
DMI IN
DC IN
USB
OPTICAL
1. OPTICAL Socket – Opticial input jack.
2.
USB Socket – Used to connect with the USB  ash disk.
3. HDMI IN Socket – Connect to a HDMI video source device (Blu-ray
player, gaming console etc.).
4. HDMI OUT (ARC) Socket – Connect to a TV via HDMI cable.
5. DC IN Socket – Socket for connecting power adapter (DC 30V/2.1A).
6. LINE IN Socket – Connect to an external audio device.
Remote control
EQ HDMI/ARC
OPT/BT
1
2
3
4
5
6
7
8
9
10
1. STANDBY – Press to switch on the unit. Press again to put the unit
in to standby mode.
2. LINE/USB – Press repeatedly to switch between LINE IN and USB
mode.
3. VOL+/VOL- – Increase/decrease the volume level.
4.
PREVIOUS – Press to return to the previous track.
5.
– Press to temporarily pause a playback. Press it again to resume
the playback. Hold down this button for 3 seconds to disconnect
bluetooth.
6. EQUALIZER – press repeatedly to switch among Music/Movie/News
equalizer modes.
7. MUTE – Press to temporarily switch o the sound. Press it again to
switch it on.
8. OPTICAL/BT – Press repeatedly to switch between Optical and
Bluetooth mode.
9.
NEXT – Press to skip to the next track.
10. HDMI/ARC – Press repeatedly to switch between HDMI and ARC
mode.
RC OPERATIONS
Insert the battery into the remote control. Point the remote control at
the remote sensor on the front panel. The remote control works within a
distance of about 8 metres from the sensor and within an angle of about
30 degrees from the left and right side.
BATTERY INSTALLATION
• Remove the battery compartment cover on the back of the remote
control.
• Insert one AAA/1.5V battery into the battery compartment making sure
that the battery has been inserted with the correct polarities matching
the symbols +, - as indicated inside the battery compartment.
• Place the battery compartment cover back onto the Remote control
First time installation
Placement and Mounting
AB