Sharp IM-MT899H - Page 25

IM-MT899H/IM-MT899W
– 25 –
: Pre-adjustment Value Check menu
: A signal offset measurement value (setting)
: B signal offset measurement value (setting)
: E signal offset measurement value (setting)
: F signal offset measurement value (setting)
: TCRS signal offset measurement value
: EF signal measurement value
: TCRS signal measurement value
: AB signal input measurement value
: Pit section adjustment COUT level setting
: Groove section adjustment COUT level setting
: A-ATT (focus) initial setting
PLAY
R S L T 1
Servo Pre-adjustment Value Check
A H
B H
SKIP UP SKIP DOWN
E H
SKIP UP SKIP DOWN
F H
SKIP UP SKIP DOWN
T H
SKIP UP SKIP DOWN
e f
SKIP UP SKIP DOWN
T C
SKIP UP SKIP DOWN
a b
SKIP UP SKIP DOWN
P C H
SKIP UP SKIP DOWN
G C H
SKIP UP SKIP DOWN
S A
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN
* When the [STOP] button is pressed in specific menu, the "TEST MODE STOP" state is set.
* In the specific setting display state the setting change digit changes when the [MODE/DISPLAY]
button is pressed.
• In the case of the setup value two digits
1st digit (initial value) 2nd digit
• In the case of the setup value three digits
1st digit (initial value) 2nd digit 3rd digit
* In the specific state the setting changes in the range of "0h to Fh" when the [VOLUME +/–]
button is pressed.
MODE/
DISPLAY
: B-ATT (focus) initial setting
: E-ATT (tracking) initial setting
: F-ATT (tracking) initial setting
S B
S E
SKIP UP SKIP DOWN
S F
SKIP UP SKIP DOWN
MODE/
DISPLAY
MODE/
DISPLAY
MODE/DISPLAY
MODE/
DISPLAY
: A signal offset measurement value
: B signal offset measurement value
: E signal offset measurement value
: F signal offset measurement value
A L
B L
SKIP UP SKIP DOWN
E L
SKIP UP SKIP DOWN
F L
SKIP UP SKIP DOWN
SKIP UP SKIP DOWN