Sharp IQ-9200

OZ-9600 II
1Q-9200
4. Pushing down the lock tab, slide off the silver battery holder.
5. Remove the old baiteries.. .
6. Insert the four new batteries, positioning them according to plus
(+) and minus (-) polarity, as indicated.
7. Line up the tab on the battery holder and slide the holder into the
unit until it clicks. Make sure that A on the unit and the indenta-
tion in the battery holder line up.
8. Slide the battery replacement switch to "USE."
9. Replace the battery compartment cover.
If nothing happens when you press a.
° Check that the battery replacement switch is set to "USE,"
¢ Check that the card lock switch is set to LOCK,
¢ Repeat the above battery replacement procedure step by step.
Replacing the memory backup battery
The Organizers memory backup battery has an expected life of ap-
proximately five years under normal conditions (temperature ex-
tremes can shorten the life of the battery).
Replace the memory backup battery every five years or whenever the
following display appears.
Replace main memory back-up battery. ‘a
Please read the operation manual for
directions.
: pea
Do not try to replace the memory backup battery of the operating
batteries are weak. Doing so may result in the loss of all data in the
Organizer. If necessary, replace the operating batteries before replac-
ing the memory backup battery.
-20-
1. Turn off the Organizer. .
2. Slide off the battery compartment cover on the back of the unit.
3. Slide the battery replacement switch to "REPL. BATT."
4. Remove the screw holding the battery cover in place.
Battery replacement -
switch
5. Slide off the battery cover.
Z
Remove the old battery using the touch pen or a similar object.
7. Insert a new battery with the plus (+) side up. : =
8. Replace the battery cover and secure it with the screw.
9. Slide the battery replacement switch to "USE.":
10. Replace the battery compartment.cover.
If nothing happens when you press :
_* Check that the battery replacement switch is set to "USE,"
s Check that the card lock switch is set to LOCK,
* Repeat the above battery replacement procedure step by step..