Sharp IQ-9200 - Page 28

OZ-9600 II
IQ-9200
Soldering the beeper leads and routing wire -
* See the figure for their locations.
¢ The terminals R (red) and B (black) must be bound on their -
given locations.
* Do not allow the leads to rest within the area A, to avoid
possible seizure by the screws.
* The beeper spacer must locate at the upper right corner of a
16MB ROM chip.
Reference line
Reference line
@ Attaching the double tack tape
* Do not allow it to extend out of the connector.
_ Reference line
Equal on center
@ Insulation sheet attachment (IQ only)
* The leads of ROM in Fig. 1 must be covered completely.
Be sure to attach the insulation sheet so that it fits with the
ROM shape.
Section B in Fig. 2 must be covered completely.
Lal tet
o = RTC
i= [a ) oa
& [ mans | [ mmm 9
WwW fm] oo
o = a
ran —— | oo
°o f canwe [ones }
[—} a
LS
Center reference
Fig. 1
® pasa the battery terminal
. Type AAA battery terminals for the main battery at four loca-
tions, including —
Fig. 2
Four locations
_ 2. Backup battery terminals (two locations)
PWB
Two locations
Binding the battery terminals with solder (Needs safety
job)
¢ Apply a-sufficient mount of solder and do not allow it to Stray.
"© The terminal must be closely attached to the PWB.
~30-
* Never cause the cabinet to melt.
eens
OK
Solder Solder
Terminal
eg
aa
te
ig
te eerimnaaasads
CAMS nny
eet ietle
Pad
Battery terminal locations
@ Attaching the pen blind sheet,
* Do not allow it to override the step.
* Do not allow to separate when attaching.
* Do not allow the blind sheet to be damaged.
Reference line
Reference line
Oo
® Screw fastening torque
* 1.640.1kgf-cm
@ Installing the junction terminal (See the figure below.)
Stretched
a
Overridden