15
Connecting to AC Disconnect
This section describes the connection between the solar power inverter and the AC disconnect. The wires needed are
the AC output cable from the solar power inverter (one pair of wires) and the grounding wire.
Follow all WARNING and CAUTION of Wiring Solar Power Inverter (page 9).
(1) Attach a forked spade or lug connector to the AC cables before connecting to the
terminal block.
Pass the wire through the gland before connecting to the terminal.
• Make sure AC disconnect is open.
• Use outdoor wiring and conduit on the outdoor section between the solar power inverter and
the PV modules.
• The AC disconnect includes over current protection.
AC terminal block for AC disconnectGND terminal
To Next Page
Loading...
