Sharp KS-M182 - Remove of Thermistor Plate Assembly; Disengage PCB Assembly; Remove of Outer Pot

REMOVE OF THERMISTOR PLATE ASS’Y
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect all lead wire from the thermistor plate ass’y to PCB ASS’Y.
3. Unbend the lead wire band bounding all the lead wire.
4. Remove the heater plate ass’y in accordance with “REMOVE OF HEATER PLATE ASS’Y”.
5. Twist 2 claws of thermistor plate ass’y.
6. Now the thermistor plate ass’y is free.
15
DISENGAGE PCB ASS’Y
1. Remove body in accordance with “REMOVE BODY”.
2. Disconnect all the lead wires of PCB ass’y.
3. Set the outer frame toward you.
4. Peel off the key sheet.
5. Remove the 3 screws fixing the PCB ass’y to the body. (Fig. 8.)
6. Now the PCB ass’y is free.
PCB ass’y fixing screws
Fig. 8.
Always replace the display cushion because it may be damaged.
CAUTION
Fig. 9.
1. Remove body in accordance with “REMOVE OF BODY”.
2. Remove the thermistor plate ass’y.
3. Turning the outer pot counterclockwise.
4. Now the outer pot is free.
REMOVE OF OUTER POT
Outer pot