53
LC-24LE240
SOFTWARE UPDATE
In MB62 project there is only one software. From following steps software update procedure can be
seen:
1. MB62 en. bin, mboot.bin and usb_auto_update_mb62.txt documents should copy directly inside
of fl ash memory ( not in a folder).
2. Put fl ash memory to the TV when TV is powered off.
3. Power on the TV by main switch and press OK in remote control continuously during 3 -4 sec-
onds. Then led will start blinking (red / green) quickly.
4. If First Time installation screen comes, it means software update procedure is successful.
To Next Page
Loading...
