C-11
Select the “Address", then input the ”0x7ffff", and press the “OK”.
Press the “Load Bin -> Flash”.
The following window will appear, then writing will start. After the finishing of the writing, window will close.
13.
UPDATE FOR VCTP SOFTWARE
14.
Finish the writing, unplug the AC cord, and remove the MICON PROGRAM JIG KIT 25-4 (JG203).
Insert the AC cord again, turn on the power.
Press both VOL. DOWN button on the set and Channel button (2) on the remote control for 2 seconds.
Confirm that displayed version agreement with writing.
15.
16.
17.
18.
To Next Page
Loading...
Need help?
General