Sharp LC-26DV200E

2 ．
Update procedure
1. Tar
g
et set is
p
ower on. Afterwards, the AC cord is disconnected.
2. The cover of the back of the set is detached.
3. USB Memor
y
that co
p
ies software onto the USB connector of the set is inserted.
*Refer to "1.Pre
p
are for USB Memor
y
" for the method of co
py
in
g
software onto USB Memor
y
.
USB Connector
SET (REAR)
Figure3：USB Connector
4. The AC cord of the tar
g
et set is inserted. The u
p
date of software starts.
while updating software.
The key is invalid while updating software.
Attention
Please do not pull out the AC cord while updating software.
When the update is completed
When the update is completed, the checksum screen is displayed in the monitor.
5. The AC cord of the target set is disconnected after the update is complete, and USB Memory is detached.
- Attention -
The checksum screen is displayed to notify the update completion.
At that time, the version before it updates it is displayed.
It is not a version of the update software.
C-4