LC-26SA1E/RU, LC-32SA1E/RU
6 – 8
<On input of the tuner (U/V)> No picture on the display (1)
No picture appears on LCD during the tuner (U/V) reception.
Checklist:
1) Is “INPUT SOURCE” button on the remote control set up correctly? ••• See the operation manual and set “INPUT SOURCE” to “TV”.
2) Is MENU-PICTURE-Contrast/Brightness set to “MIN”? ••• Set it to an appropriate level.
3) Is ANT-CABLE disconnected or connected improperly? ••• Connect it correctly as per the operation manual.
YES
Is level of pins (4) and (5) of tuner (TU201) and pins (10) and (11)
of IC201 (IF-DEMOD) at H?
NO These are communications lines for control (I2C). Follow the
path and check whether they are forced to L (PULL_DOWN).
YES
Is the video signal (IF) sent from pin (11) of tuner (TU201)? NO Check the tuner (TU201) and peripheral circuits.
YES
Is video signal sent from pin (17) of IC201 (IF-DEMOD)? NO Check FL201 (SAW-FIL), IC201 and peripheral circuits.
YES
Is the video signal VIN1 (ATUNER-CVBS) sent to pin (191) of
lC3002 (VCT)?
NO Check IC201 (IF-DEMOD), CONNECTOR (P201 /SC2705) and
peripheral circuits.
YES
Is LVDS video signal (LVDS_0N/0P-3N/3P) sent to pins (141)/
(140) - (129)/(128) of IC3002 (VCTP), and is CLK signal
(LVDS_CN/CP) sent to pins (132)/(131)?
NO Check pins (192)/(170)/(133) of BU3.3V line of IC3002 (VCTP),
pins (185)/(169)/(142) of 1.8V line and peripheral circuits.
YES
Is LVDS video signal (LVDS_0N/0P-3N/3P) sent to pins (12)/(13)
-(24)/(25) of CONNECTOR CN1 of LCD-CONT-UNIT, and is CLK
signal (LVDS_CN/CP) sent to pins (21)/(22)?
NO Check CONNECTOR (P2305, CN1) and HARNESS WIRE (LV).
YES
Is power (LCD5V) supplied to pins (2) - (5) of CONNECTOR CN1
in LCD-CONT-UNIT?
NO Is LCD5V supplied to pins (31) - (28) of CONNECTOR (P2305)?
Check HARNESS WIRE (LV).
YES
Replace LCD-CONT-UNIT.
To Next Page
Loading...
Need help?
General