Watching TV
Selecting a sound mode
DTV mode:
If multi sound modes are received, each time you
press 2 the mode switches as follows.
Audio (ENG) : STEREO
L/R LRLR
Audio (ENG) : CH A
CH A CH B CH AB
Audio (ENG) : MONO
Press c/d to select L or R sound when the STEREO
or DUAL MONO screen is displayed.
Audio (ENG) : STEREO
L/R L RLR
NOTE
The sound mode screen disappears in six seconds.
Selectable items vary depending on the received broadcasts.
ATV mode:
Each time you press 2, the mode switches as
shown in the following tables.
NICAM TV broadcasts selection
Signal Selectable items
Stereo
NICAM STEREO, MONO
Bilingual
NICAM CH A, NICAM CH B, NICAM CH AB, MONO
Monaural
NICAM MONO, MONO
A2 TV broadcasts selection
Signal Selectable items
Stereo
STEREO, MONO
Bilingual
CH A, CH B, CH AB
Monaural
MONO
NOTE
When no signal is input, the sound mode will display “MONO”.
E
•
•
E
•
Watching analogue
broadcasts
EWatching digital
broadcasts
E
Daily operation
Switching on/off
Turning on/off the power
Press a on the TV.
Switch it off by pressing a on the TV.
Standby mode
To standby mode
If the TV is switched on, you can switch it to standby
by pressing B on the remote control unit.
Switching on from standby
From standby, press B on the remote control unit.
TV indicator status
B indicator
Status
Off
Power off
Green
Power on
Red
Standby
NOTE
If you are not going to use this TV for a long period of time, be sure
to remove the AC cord from the AC outlet.
A small amount of electric power is still consumed even when a is
turned off.
E
E
•
•
Switching between analogue and
digital broadcasts
Changing channels
With 0–9:
With Pr/s:
Selecting an external video source
Once the connection is made, press
b to display the “INPUT SOURCE”
screen, and then press a/b to
switch over to the appropriate
external source with OK.
10
NOTE
When turning off the power using
a on the TV, EPG data (Electronic
programme guide) will be lost, and
programmed timer recordings will
not be performed by the TV.
•
INPUT SOURCE
TV
EXT1
EXT2
EXT3
EXT4
HDMI1
To Next Page
Loading...
Need help?
General