Other useful features
Input Select
Option
For setting the signal type of external equipment.
NOTE
If no (colour) image displays, try changing to another
signal type.
Check the operation manual of the external equipment for
the signal type.
•
•
Input Label
Setup
You can label each input source with a custom
description.
Press b to select the desired input source.
Go to “MENU” > “Setup” > “Input Label”.
Press a/b/c/d to select each character of the
new name for the input source, and then press
OK.
A
BACK
CLEAR
END
K
U
B
L
V
C
M
W
D
DVD
N
X
E
O
Y
F
P
Z
G
Q
+
H
R
– _
I
S
.
J
T
0 1 2 3 4 5 6 7 8 9
Repeat until the label is fully spelt out.
NOTE
The label can be six characters or less.
When you want to set an input source label of less than six
characters, select “END” to set the name.
INPUT SOURCE
TV
EXT1
EXT2
DVD
EXT4
HDMI1
EXT6
NOTE
You cannot change labels if the input source is “TV” or
“USB”.
1
2
3
4
•
•
•
Input Skip
Setup
This setting allows you to skip the SCART, HDMI or
RGB input on the Input Source Selection operation.
EXT1 (SCART)
EXT2 (SCART)
EXT4 (RGB)
HDMI1
HDMI2
HDMI3
Y es
No
Colour system settings
You can change the colour system to one that is
compatible with the image on the screen.
NOTE
The factory preset value is “Auto”.
If “Auto” is selected, the colour system for each channel
is automatically set. If an image does not display clearly,
select another colour system (e.g. “PAL”, “SECAM”).
Additional features
•
•
Quick Start
Setup
You can reduce the TV’s start-up time after turning on
the power with the remote control unit.
Colour System
Option
Setting when using external
devices
Input source settings
EXT1: Y/C, CVBS, RGB
EXT2: Y/C, CVBS, RGB
Skipping specified inputs
On: The TV quickly starts up from standby. 30 W or more
of power consumption is required during standby.
Off: Power consumption is small during standby.
33
Item
Item
To Next Page
Loading...
Need help?
General