Appendix
Download Setup
Digital Setup
Message List
Information
Go to “MENU” > “Setup” > “Reset”.
Press c/d to select “Yes”, and then press OK.
“Now, TV will restart automatically. OK?” displays on
the screen.
Press c/d to select “Yes”, and then press OK.
“Now initialising...” displays on the screen and blinks.
After the reset has completed, the power shuts
off and then comes back on. The screen will have
returned to its original settings.
Now initialising...
1
2
•
3
•
•
Reset
Setup
Identification
Setup
Receiver Report
Information
Display reports regarding failures and changes for
timer settings.
Reset
If complex adjustments are made so that the settings
cannot be restored to normal, you can reset the
settings to the factory preset values.
Searching for updates*
All countries except UK and Sweden are set to “No”
for this function.
The TV automatically determines whether a new
software version is available when the TV is in standby
mode.
*
Updating your TV via DVB-T
Ensure that your TV software version is always up to
date. From time to time SHARP will make updated TV
base software and DVB software available.
Yes: Automatically searches for new software updates
available when the TV is in standby mode.
No: Does not search for update information.
Now: Checks if there is new software immediately.
Downloading the software
You can select the method of update.
If the software is updated, the confirmation
message “New download information has been
detected.” appears.
If the TV receives the update service while in standby
mode, a confirmation message displays after turning
on the power.
Follow the screen prompts.
1
•
2
Yes: Starts downloading immediately. It takes
approximately one hour to update. You cannot carry
out other operations while downloading.
Cancels the download by pressing OK on the remote
control unit when “Discontinue” is displayed on the
screen during the update.
No: Starts downloading automatically several minutes
after entering standby mode.
•
When new software is detected, you can confirm the
update information and download the software from
“Message List”.
NOTE
When the TV succeeds at downloading new software,
the message is updated in the “Message List” of the
“Information” menu.
The software update will not be carried out if there is no
new software available at the specified download time.
•
•
Identification
CLEARING THE PIN
Go to “MENU” > “Setup”.
Press a/b to select “Auto Installation”,
“Programme Setup”, “Child Lock” or “Reset”,
and then press OK. The PIN input window will
display.
Press and hold both Pr and ik on the TV
simultaneously until the message appears on
the screen.
1
2
3
You can check the TV ID on the screen for reporting to
customer service.
NOTE
The TV must remain in standby mode for download. Do not
turn off the power using a on the TV.
Updating the software may take some time.
•
•
41
Item
Item
To Next Page
Loading...
Need help?
General