Sharp LC-32LE225E

25
LC-32LE225
6. Video Signal Adjustment Procedure
6.1. RGB SCART ADC
1. Enter in Service mode.
2. Press “▼” until selecting “ADC ADJUST” option.
3. Press “OK”.
4. “ADC ADJUST” menu appears.
5. Press “▼” until selecting “ADJUST” option.
6. Press “►”until selecting “Internal Signal”.
7. Press “▲”until selecting “MODE” option.
8. Press “►”until selecting “RGB”.
9. Press “▼” until selecting “AUTO ADC” option.
10. Press “►”, the adjustment starts.
11. “SUCCESS” appears when the adjustments fi nish.
12. Exit of Service mode.
6.2. COMPONENTS ADC
1. Enter in Service mode.
2. Press “▼” until selecting “ADC ADJUST” option.
3. Press “OK”.
4. “ADC ADJUST” menu appears.
5. Press “▼” until selecting “ADJUST” option.
6. Press “►”until selecting “Internal Signal”.
7. Press “▲”until selecting “MODE” option.
8. Press “►”until selecting “YPbPr(SD)” or “YPbPr(HD)”
9. Press “▼” until selecting “AUTO ADC” option.
10. Press “►”, the adjustment starts.
11. “SUCCESS” appears when the adjustments fi nish.
Note: both SD and HD are adjusted.
12. Exit of Service mode.
6.3. PC IN RGB ADC
1. Enter in Service mode.
2. Press “▼” until selecting “ADC ADJUST” option.
3. Press “OK”.
4. “ADC ADJUST” menu appears.
5. Press “▼” until selecting “ADJUST” option.
6. Press “►”until selecting “Internal Signal”.
7. Press “▲”until selecting “MODE” option.
8. Press “►”until selecting “PC-RGB”.
9. Press “▼” until selecting “AUTO ADC” option.
10. Press “►”, the adjustment starts.
11. “SUCCESS” appears when the adjustments fi nish.
12. Exit of Service mode.