Sharp LC-37XD1RU - Video Signal Adjustment; RF AGC Adjustment

LC-37XD1E/RU SUPPLEMENT
1 – 2
4. Adjustment process mode menu
The character string in brackets [ ] will appear as a page title in the adjustment process menu header.
5. Video signal adjustment procedure * The adjustment process mode menu is listed in Section 5.
1. Signal check
Signal generator level adjustment check (Adjustment to the specified level)
• Composite signal PAL : 0.7Vp-p ± 0.02Vp-p (Pedestal to white level)
• 15K component signal : Y level 0.7Vp-p ± 0.02Vp-p (Pedestal to white level)
(50 Hz) PB, PR level 0.7Vp-p ± 0.02Vp-p
2. Entering the adjustment process mode
Enter the adjustment process mode according to Section 3.
3. RF AGC adjustment 1
Page Line
1/13 [INFO]
1 Main Version
37XD1B ver 2.31 2007.03.15
Main microprocessor version
2 Dev Version ver 1.151 DTV version.
3 Dev Loader Version 2.7 DTV Loader Version
4 Center Acutime xxxxH xxM Main operating hours
5 Backlight Acutime xxxxH xxM Backlight operating hours
6 Temp Sensor 080
Temp Sensor setting
7 Normal Standby Cause 1 RC_STANDBY
8 Error Standby Cause [1]
1c POWER ERROR 0000H 00M
Error standby cause Total operating time before error
[2]
1c POWER ERROR 0000H 00M
[3]
1c POWER ERROR 0000H 00M
[4]
0 0000H 00M
[5]
0 0000H 00M
2/13 [INIT]
1 FACTORY INIT
EURO/UK/ITALY/FRANCE/RUSSIA
Initialization to factory settings execution
2 INCH SETTING Inch Setting
3 PUBLIC MODE off/on HOTEL MODE㵘flag setting
4 Center Acutime Reset off/on Main operating hours Reset
5 Backlight Acutime Reset off/on Backlight operating hours Reset
6 Picture Read Pos X 670 x-axis setting of picture data
7 Picture Read Pos Y 419 y-axis setting of picture data
8 Picture Read Signal Type PAL/COMP/HDMI/RGB Signal Type Setting
9 Picture Read 0 - 1023 Start/stop of picture data
Item
Remarks (adjustment detail,etc.)
Description
1 Setting [Signal]
䊶
Feed the PAL Split Field colour bar signal (E-12ch) to TUNER.
PAL
㵘 Signal level: 65dB V㵘±1dB 㵘㵘(75 Ω LOAD)
Split Field Colour Bar
RF signal UV [E-12CH]
[Terminal]
TUNER
㸡100% white
2
Auto adjustment Adjustment process Bring the cursor on [ RF AGC BG ADJ] and press [OK]
performance
Page 3
[ RF AGC BG ADJ 㵘OK] appears when finished.
Adjustment Conditions Adjustment㵘procedure Adjustment poin t