QUICK REFERENCE
n LC-9OLE657U/LC -80LE657U/LC-SOLE65OU/
LC-SOC65OOU
1 Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
2 _} Set the post for the stand unit onto the
polystyrene foam.
@_Attach the base to the post.
@_Inser_ and tighten the 8 screws into the 8
holes on the bottom of the base.
• Hold the stand unRsecurely wRh one hand,
and then tighten the screws.
[] Lc-gOLE657U
®
_) _i._ _ _ Long
......
[] LC-80LE657U/LC-80LE650U/LC-80C6500U
_ Long @
®
• A _ • =
1 Attach your antenna to the back of the television.
(See page 10.)
2 Connect the AC plug for the television into the
AC outlet.
• Place the TV close to the AC outlet, and keep the
power plug wRhin reach.
[] LC-80LE857U/LC-80LE757U
[] LC-90LE657U/LC-80LE657U/LC-80LE650U/
LC-80C6500U
[] LC-60LE657U/LC-60LE655U/LC-60LE650U/
LC-6006500U
Bundle the cords properly with the cable tie.
• When bundling the cords, use the AC cord holder
mounted on the TV. Relocate from _} to {B}.
[] LC- 70LE857U/LO-60LE857U
Attach andbundle together
[] LC- 70LE757U/LO-60LE757U/LC- 70LE755U/
LC-60LE755U/LC- 70LE750U/LC-60LE750U/
LC- 70C7500U/LC-60C7500U
3 When turning ors the IV for the first time. press
POWER on the television.
4 Inser_ the batteries into the remote control unit.
(See page 10.)
• Speakers cannot be detached from the TV.
• The TV angle cannot be adjusted.
e= . • D .e =
An HDTV without an HD source is just an ordinary TV.
To enjoy HD images on the TV, you should get
HD programming from the following:
®Over4he-air broadcasting via HI) quality antenna
,, HD cable/satellite subscription
,, HD compatible external equipment
• For information on updating to HD programming, ask
your cable/satellite service provider,
3
4
Build the work table. (See page 7.)
_} Inser_ the stand into the openings on the
bottom of the lV.
• Make sure that the stand is firmly inserted into
the TV. Improper installation may resuRin tiring
of the TV set.
@] Inser_ and tighten the 4 screws into the 4
holes on the rear of the TV.
Short screws Soft cushion
• "1 : Be sure to use the clamp to prevent the AC
cord from being unplugged.
(Except for LC-90LE657U)
[] LC- 70LE657U/LC- 70LE655U/LC- 70LE650U/
LC-70C6500U
Attach and bundle together
• TO PREVENT RISK OF ELECTRIC SHOCK, DO
NOT TOUCH UN4NSULATED PARTS OF ANY
CABLES WITH THE AC CORD CONNECTED.
(D-9
To Next Page
Loading...
Need help?
General