QUICK REFERENCE
® Before attaching (or detaching) the stand, unplug the AC cord, 1 Attach your antenna to the back of the television, (See page 6,)
® Before performing work spread cushioning over the base area to lay the IV on, This will prevent it from 2 Connect the AC plug for the television into the AC outlet,
being damaged, ® Place the lV close to the AC outlet, and keep the power plug within reach,
,, Be sure to follow the instructions, Incorrect installation of the stand may result in the "IV falling over,
1 Confirm that there are 4 screws supplied with the stand unit.
2 Put the TV face down on a safe surface that is covered by a soft and smooth cloth,
3 Attach the TV stand to the bottom of the lV,
4 Fasten the 4 screws by using a crosshead screwdriver.
" Do not push too hard or put excessive pressure to the stand neck to avoid damage to the TV.
o Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
o After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the
TV.
, TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES
WITH THE AC CORD CONNECTED,
3 When turning on the TV for the first time, press POWER on the TV.
POWER
4 Irlsert the batteries into the remote control unit, (See page 6.)
• Speakers cannot be detached from the TV.
• The TV angle cannot be adjusted.
• To detach the stand, perform the steps in reverse order.
(D-5
To Next Page
Loading...
Need help?
General