LC-32D47U/LC-32SB27U/LC-C3237U
5 – 22
6.2. TEMP Adjustment
6.2.1 Receive US-10ch(JPN-8ch) the standard color bar signal
6.2.2 See if the “YDATA” reading (maximum) on Adjustment Process Page 1 is within the range in the follow table. If not,
adjust the “TEMP ALL” setting on the same page to have the “YDATA” reading (maximum) within this range.
Refines
(Adjustment Process Menu Page 1)
6.3. Tuner/V-Chip test
MODEL
SETTING VALUE (NTSC) 163-170
01234567891011121314151617181920212223242526
0DVP1
1TAMP1L 163
2YDATA 98
3TAMP1H 170
4TAMPALL OFF
5NTSCTAMP1 77
6PAL–MTAMP 64
7PAL–NTAMP 64
Adjustment item Adjustment conditions Adjustment procedure
1 Adjustment NTSC RF signal
US-7 (AIR) ch
Feed the NTSC signal to RF ANTENNA input.
2 Auto adjustment
performance
Bring the cursor on [OTHERS]→[OTERRS2]→[.TUNER VCHIP TEST (*07ch)]
and press [LEFT]. (*Select the channel according to the RF signal.)
[.A-OK (***.**)/VM-OK] appears in blue when finished. (If [A-NG/VM-NG] appears
in yellow or red, the test is incomplete.)
Make sure a displacement of ±0.0625 MHz from the center frequency is accept-
able.
To Next Page
Loading...
