Sharp LL-S201A - Classic menu; Setting to classic menu

ENGLISH
7
E
n
Mounting the monitor on the stand
1. Place the stand on a level surface.
2. Set the monitor on the stand.
Set the monitor so that the logo in the center is aligned with
the circle mark on the stand.
Logo
Circle mark
TIPS
• The stand and the monitor can be secured with xing
screws.
Fixing screws (supplied)
Pen writing position
Place the monitor at an angle on a table or other level surface.
1. Holdtheapbythedepressiononthebackofthe
monitorandpulltheapup.
Depression
2. Place the monitor where you want to use it.
Caution
• Do not exert a large amount of force on the monitor from
above. Doing so may damage the ap.
Horizontal position
Place the monitor on a table or other level surface.
Caution
• When using the monitor horizontally, use the horizontal tab
in the upright position.
1. Lift up the two tabs on the back of the monitor.
2. Place the monitor where you want to use it.
Caution
• Do not exert a large amount of force on the monitor from
above. Doing so may damage the tabs.