MD-E9000H
– 22 –
ADJUSTMENT
Figure 22 ADJUSTMENT POINTS
Test Stage
Frequency Frequency
Display
Setting/
Adjusting
Parts
Instrument
Connection
• AM IF/RF
Signal generator: 400 Hz, 30%, AM modulated
*1. Input: Antenna Output: TP302
*2. Input: Antenna Output: TP301
TUNER SECTION
fL: Low-range frequency
fH: High-range frequency
AM IF 450 kHz 1,620 kHz T351 *1
AM Band — 522 kHz (fL): T306 *2
Coverage 1.1 ± 0.1 V
AM Tracking 990 kHz 990 kHz (fL): T303 *1
• FM
Notes:
1: Description of the "FM IF Adjustment" is not carried on this
Manual. It is because the IF coil in the FM front end section
has been best adjusted in the factory so that its further
adjustment is not needed at the field. When replacing the
FM front end assembly, no adjustment is needed either.
2: The parts in the FM front end section are prepared in a
complete unit, so you can't obtain each part individually.
CNP301
SO301
FM ANTENNA
TERMINAL
FE301
T303
TP301
TP302
T306
R356
R336
T351
TUNER PWB
AM IF
AM TRACKING
fL
AM BAND
COVERAGE fL
To Next Page
Loading...
