MD-E9000H
– 4 –
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE REFER
TO THE OPERATION MANUAL.
SPECIFICATIONS
Specifications for this model are subject to change without
prior notice.
IMPORTANT SERVICE NOTES (FOR U.K. ONLY)
Before returning the unit to the customer after completion of a
repair or adjustment it is necessary for the following withstand
voltage test to be applied to ensure the unit is safe for the
customer to use.
Setting of Withstanding Voltage Tester and set.
Set name set value
Withstanding Voltage Tester
Test voltage 4,240 VPEAK
3,000 VRMS
Set time 6 secs
Set current (Cutoff current) 4 mA
Unit
Judgment
OK: The “GOOD” lamp lights.
NG: The “NG” lamp lights and the buzzer sounds.
PROBE
AC
OUT
UNIT
SHORT-CIRCUIT
AC POWER
SUPPLY CORD
CONNECT THE PROBE
TO GND OF CHASSIS
SCREW
WITHSTANDING
VOLTAGE TESTER
MD-E9000H
CP-E9000H
MiniDisc
Type MiniDisc recorder
Signal readout Non-contact, 3-beam semiconductor laser pickup
Rotation speed 400 - 900 rpm CLV, Approx.
Error correction ACIRC (Advanced Cross Interleave Reed-Solomon
Code)
Quantization 20-bit linear (A/D converter)
Coding ATRAC/ATRAC 3 (Adaptive TRansform Acoustic Cod-
ing)
Sampling frequency 44.1 kHz
Recording method Magnetic modulation overwrite method
Frequency response 20 - 20,000 Hz
D/A converter 1-bit D/A converter
Wow and flutter Unmeasurable (less than 0.001% W. peak)
Signal/noise ratio 95 dB (1 kHz)
Dynamic range 90 dB (1 kHz)
Audio channel Stereo: 2 channels (SP, LP2, LP4)
Tuner
Frequency range FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Type 2-way type speaker system
5 cm (2") Tweeter
10 cm (4") Woofer
Maximum input power 40 W
Rated input power 20 W
Impedance 4 ohms
Dimensions Width: 140 mm (5-9/16")
Height: 300 mm (11-13/16")
Depth: 187 mm (7-3/8")
Weight 1.5 kg (3.3 lbs.)/each
General
Power source AC 230 V, 50 Hz
Power consumption Power on: 50 W
Power stand-by: 0.6 W (*)
Dimensions Width: 230 mm (9-1/16")
Height: 173 mm (6-13/16")
Depth: 290 mm (11-7/16")
Weight 4.1 kg (9.0 lbs.)
(*) This power consumption value is obtained when the demonstration mode is can-
celled in the power stand-by mode. To cancel the demonstration mode.
Amplifier (Except for U.K.)
Output power PMPO: 132 W (Total)
MPO: 66 W (33 W + 33 W) (DIN 45 324)
RMS: 40 W (20 W + 20 W) (DIN 45 324)
RMS: 28 W (14 W + 14 W) (DIN 45 500)
Output terminals Speakers: 4 ohms
Headphones: 16 - 50 ohms (recommended: 32 ohms)
Input terminals Auxiliary: 500 mV/47 kohms
CD player
Type Compact disc player
Signal readout Non-contact, 3-beam semiconductor laser pickup
D/A converter 1-bit D/A converter
Frequency response 20 - 20,000 Hz
Dynamic range 90 dB (1 kHz)
Amplifier (For U.K.)
Output power MPO: 66 W (33 W + 33 W) (10 % T. H. D.)
RMS: 40 W (20 W + 20 W) (10 % T. H. D.)
RMS: 28 W (14 W + 14 W) (1kHz 0.9 % T. H. D.)
Output terminals Speakers: 4 ohms
Headphones: 16 - 50 ohms (recommended: 32 ohms)
Input terminals Auxiliary: 500 mV/47 kohms
To Next Page
Loading...
Need help?
General
