– 33 –
MD-E9000H
The details description of mechanism error
Error Display Error Message
E r - M D 1 Cannot eject the disc.
E r - M D 2 The head does not ascend.
E r - M D 3 The head does not descend.
HINF
(93 Pin of IC1401)
= E EJECT complete position < 1.4 V
= M LOAD/EJECT halfway position > 3 V
= L LOAD complete position 2.475 ~ 2.8 V
= D HEAD DOWN position 2.0875 ~ 2.2375 V
EEPROM WRITING PROCEDURE
EEPROM (IC1402) writing procedure
1. Method for setting the reference temperature value
(This setting should be performed quickly at a room
temperature, between 21°C to 29°C when the PWB is not
hot.)
1
When replacing the EEPROM, wait until it has cooled
down.
2
Connect the main unit using the single MD main PWB.
3
Enter the test mode as shown on page 24.
"EJECT"
4
Press the NORMAL CD MD EDIT button.
"TEMP "
: Measured temperature, : Temperature setting
5
Find the temperature correction value for the current
ambient temperature on the following table. Adjust the
temperature correction value using the VOLUME UP/
DOWN button.
Ambient Temperature
Correction
+ 21.0 °C ~ + 23.2 °C -1 H
+ 23.3 °C ~ + 26.8 °C ± 0 H
+ 26.9 °C ~ + 29.0 °C +1 H
An example: When ambient temperature is 22 °C and
measured temperature is 7A H
Temperature setting = 7A H - 01 H
= 79 H
* When the measured temperature fluctuates
between two values, take lower one (if
temperature fluctuates between 7A H and
79 H, take 79 H).
6
Press the POWER button and write the temperature
setting into the EEPROM.
2. Method for making settings other than the reference
temperature
1
Install the MD main PWB in the mechanism, and connect
it to the main unit.
2
Enter the test mode as shown on page 24, and insert a
disc.
"AUTO AJST"
3
Press the CD PLAY button seven times.
"EEPROM SET"
4
Set the value according to the EEPROM DATA LIST
using the VOLUME UP/DOWN button.
5
Press the POWER button, and the settings will be written
into the EEPROM.
6
Enter the test mode again, perform an "AUTO YOBI
adjustment", and write the results into the EEPROM.
S P G 1 1
H
S P G — i n 6 0
H
S P G — m i d 4 B
H
S P G — o u t 3 B
H
S P G M 9 6
H
S P 1 1 0
H
S P 2 9 3
H
S P 2 2 9 3
H
S P 3 E D
H
S P 4 E E
H
S P 5 2 0
H
S P 5 2 2 0
H
S P D L I M 6 2
H
S P K L E V m 1 6
H
F G 9 B
H
F G 2 B 1
H
F F 0 1 0
H
F F 1 7 0
H
F F 2 E 0
H
F Z H L E V E D
H
F O K L E V h 0 7
H
F O K L E V L 0 9
H
F O S T n 2 C
H
D S C J G 0 D
H
EEPROM DATA LIST (Version : 01)
Focus setting
Item indication Setting
Spin setting
Item indication Setting