16
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Preparation
– Hold Function –
Hold Function
The present operation condition can be kept even if other buttons are accidentally pressed in a place such
as a crowded train.
To cancel the hold mode:
Move the HOLD switch away from the safety posi-
tion (the opposite direction of the arrow).
Hold
Release
Press the • ■ / :OFF button for 2 seconds or more.
Move the HOLD switch to the safety position
(direction indicated by the arrow).
Orange mark
● If the hold function is active whilst the power is
turned off, the power cannot be turned on by
mistake and the battery will not be drained.
● If the alkaline batteries are inserted or the AC adaptor
is connected, you can set this function even when the
power is turned off.
To cancel the hold mode
Press and hold down for 2 seconds or more whilst the unit
is in the hold mode.
● “HOLD OFF” will be shown
Remote control unit
Main unit
Hold
To Next Page
Loading...
Need help?
General
