39
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Useful Features
– Changing Default Settings –
Changing Default Settings
Beep sound
You can eliminate the confirmation sound that beeps
when you press a button.
Display backlight on the remote control
“EL ON 1”
When any button is pressed, the backlight will re-
main lit for about 10 seconds.
“EL ON 2”
When the rechargeable battery, alkaline battery
or car adaptor is used, the backlight will remain lit
for about 10 seconds.
When the battery charger is used and the power
is turned on, the backlight will always be lit.
“EL OFF”
Light will not be turned on.
Auto play
You can make the unit not play automatically when
you insert a playback-only MiniDisc or an accidental
erasure protected MiniDisc.
Auto power save
When the unit is used in a place exposed to much
vibration, sound skipping can be decreased by can-
celling the auto power save function. (Battery will
drain faster.)
What is auto power save function?
Auto power save function automatically adjusts the sound
skip memory storage to be from 5 to10 seconds depend-
ing on playback conditions, this saves battery power.
If the MiniDisc unit is used in areas of much vibration it
may be necessary to fix the sound skip memory to 10
seconds “Psave OFF (PS off)” this will improve perfor-
mance under difficult conditions but uses more power.
(When the AC/car adaptor is used the 10 second mode
is always used.)
Digital recording level
“D.L MODE 1”
The digital recording level you set will be kept even
after canceling recording.
“D.L MODE 2”
Every time you cancel recording, the level will re-
turn to [ D.L 0dB ].
Refresh
If you charge the battery before it runs out completely,
the operating time may be shortened. To avoid this,
the battery will be discharged and refreshed auto-
matically. You can cancel this function.
LCD edge light
Whilst in [ LIGHT ON ] mode, LCD edge lights flash
according to the function.
To Next Page
Loading...
Need help?
General
