Sharp MD-MX20 User Manual

13
COMPACT DISC OPERATION
■ CD playback
1 Press the ON/STAND-BY button to turn the power on.
2 Press the CD ■ button.
3 Press the
77
77
7 button to open the disc tray.
4 Place the CD on the disc tray, label side up.
● Be sure to place 3" (8 cm) CD in the middle of the disc
tray.
5 Press the
77
77
7 button to close the disc tray.
● The total number of tracks and the total playing time will
be displayed.
Total number of tracks Total playing time
6 Press the CD
0606
0606
06 button to start playback from track 1.
● When the last track has been played back, the unit will
stop automatically.
To interrupt playback:
Press the CD 06 button.
● “ 6 ” will appear.
● Press the CD 06 button again to resume playback from
the same point.
To stop playback:
Press the CD ■ button.
To remove the CD.
Press the
77
77
7 button.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Caution:
● Do not carry the unit with a CD left in the disc tray. The
disc may come loose inside the unit and it may be dam-
aged or cause damage to the unit. This may also cause
malfunctions.
● Do not push the disc tray while it is moving.
● If the power fails while the tray is open, wait until the power
is restored.
● If the disc tray is stopped forcibly, "E-CD20" will appear in
the display and the unit will not function.
If this occurs, press the ON/STAND-BY button to enter the
stand-by mode and then turn the power on again.
● Subjecting the unit to shock or vibration may cause mistracking.
● Playing certain CDs at a high volume may cause mistracking.
In this case, listen at a lower volume.
● If TV or radio interference occurs during CD operation, move
the unit away from the TV or radio.
1
3,5
6
2
1
6
4
Label side up
3" (8 cm)
5" (12 cm)
2

Sharp MD-MX20 Specifications

General

Brand	Sharp
Model	MD-MX20
Category	Speaker System
Language	English