Sharp MX-2300 G - Page 58

MX-2300/2700 N/G AR-PN1A/B/C/D 9 – 1
MX2700N
5GTXKEG/CPWCN

[9] AR-PN1A/B/C/D
1. Unpacking
A. Removal of the punch unit
B. Check the packed items
1) Check that all the items are included in the package.
* The punch position labels (No.5 and No.6) and must be those
bundled with the MX-FNX2 rather than those bundled with the
AR-PN1A/B/C/D.
2. Installation
<Note before installation>
* Before starting installation, check to insure that the data lamp on
the operation panel does not light up or blink.
A. Turn off the power of the main unit
1) Turn OFF the power switch on the operation panel.
2) Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
3) Remove the earth cord and disconnect the power plug of the
main unit from the power outlet.
4) Disconnect the connector between the main unit and the sad-
dle finisher.
No. Packed part names Quantity
1 Harness A (Purple) 1
2 Harness B (Orange) 1
3 Fixing screw (M4 x 6 with tooth lock washer) 1
4 Dust box label 1
5 Punch position label (For scanner) * 1
6 Punch position label (For RSPF) * 1
12
3
45
6
OFF
OFF
OFF