MX-3610N MX-DE12/DE13/DE14 (STAND/1x500/2x500/3x500 SHEET PAPER DRAWER) 4
– 4
F. Image off-center adjustment
The image lead edge position and the off-center adjustment value
of the desk unit have been set to the average value when shipping
from the factory.
Therefore, this adjustment must be performed only when the judg-
ment is made to execute it through checking the print image.
1) Enter the SIM50-28 mode.
2) Select [SETUP/PRINT] ADJ with the key button.
3) Select [ALL] with the key button.
By pressing [LEAD] or [OFFSET] button, the following items
can be executed individually.
• [LEAD]: Print image lead edge image position adjustment
• [OFFSET]: Print image off-center adjustment
When [ALL] is selected, both of the above two items are
executed simultaneously.
4) Select a paper feed tray to be adjusted.
5) Press [EXECUTE] key.
The patch image (adjustment pattern) is printed out.
6) Set the adjustment pattern on the document table.
Fit the adjustment pattern correctly with the document guide.
In this case, put 5 sheets of white paper on the printed adjust-
ment pattern.
7) Press [EXECUTE] key.
The following item is automatically adjustment.
• Print image lead edge image position adjustment
• Print image off-center adjustment
8) Press [OK] key.
The adjustment result becomes valid.
Perform procedures 4) to 7) for each paper feed tray.
To Next Page
Loading...
