Sharp MX-2610N - Page 49

SHARP
TROUBLE CODES
49
F1
00
Finisher-PCU PWB communication error.
03
Finisher exit roller lifting trouble
08
Finisher staple shift motor trouble.
10
Finisher staple operation trouble.
11
Finisher grip operation trouble.
15
Finisher exit tray lift operation trouble.
19
Finisher alignment operation trouble F.
20
Finisher alignment operation trouble R
21
Finisher interface fan motor trouble.
31
Saddle Finisher folding sensor trouble.
32
Finisher/Punch communication error.
33
Punch unit shift operation trouble.
34
Punch operation trouble.
37
Finisher data backup RAM error.
38
Punch data backup RAM trouble.
39
Punch paper dust sensor trouble.
41
Saddle paper positioning trouble
43
Saddle alignment operation trouble.
45
Saddle staple trouble.
47
Saddle paper transport motor trouble.
50
Finisher incompatibility trouble.
F2
22
Discharge lamp trouble K
23
Discharge lamp trouble C
24
Discharge lamp trouble M
25
Discharge lamp trouble Y
39
Process thermistor breakdown
40
Toner density sensor trouble K
41
Toner density sensor trouble C
42
Toner density sensor trouble M
43
Toner density sensor trouble Y
45
Colour image density sensor trouble
49
LSU thermistor trouble
50
Drum phase sensor trouble (Black)
51
Drum phase sensor trouble (Colour)
58
Humidity sensor trouble (process)
64
Toner supply error K
65
Toner supply error C
66
Toner supply error M
67
Toner supply error Y
70
Improper toner cartridge detection K
71
Improper toner cartridge detection C
72
Improper toner cartridge detection M
73
Improper toner cartridge detection Y
74
Toner cartridge CRUM error K
75
Toner cartridge CRUM error C
F2
76
Toner cartridge CRUM error M
77
Toner cartridge CRUM error Y
78
Image density registration sensor trouble
91
High density process control HV error (K)
92
High density process control HV error (C)
93
High density process control HV error (M)
94
High density process control HV error (Y)
F3
12
Lift up trouble Cassette 1 (Main unit)
22
Lift up trouble Cassette 2 (Main unit)
F6
00
ICU-Fax communication trouble (ICU)
01
Fax EEPROM read/write error.
04
Fax modem operation trouble.
21
LIU & Fax soft switch error (combination)
30
Access error to 1-chip on Fax board.
97
Fax Pwb compatibility trouble.
98
Improper combination of Fax &
Destination information.
F9
91
Communication error (MFP & printer)
92
Printer PWB hardware error
H2
00
Non contact thermistor open
(TH_UM_AD2).
01
Lower thermistor open (TH_LM).
02
Sub thermistor open (TH_US).
03
Compensation thermistor open trouble
(TH_UM_AD1)
H3
00
Fuser high temperature (TH_UM).
01
Fuser high temperature (TH_LM).
02
Sub thermistor fusing section high
temperature (TH_US).
H4
00
Fuser low temperature (TH_UM_AD2)
01
Fuser low temperature (TH_LM)
02
Sub thermistor fusing section low
temperature (TH_US)