Is there a trial mode available for the
Web Browsing Kit?
Yes: Use Sim 26-71 to enable (Limit of 19000 pages).
Note: PDF viewer & Flash are not supported
Unable to print PDF documents when
using web browser function
To print PDF documents via the web browser, the PS
option (MX-PK11) must be installed.
Slow operation and/or machine
performance (including slow
browsing of the MFP webpage).
Backup and clear the job log data (especially when the
job log exceeds 60,000 entries).
SRDM does not show status of copier
SRDM ( Sharp Remote Device Manager )gets data from
the copier using SNMP . If this is disabled by using SIM
55-3 Sw. 9 , bit 5 , then SRDM cannot monitor the status
of the copier .
Note that the copier needs to be power cycled at the
mains for changes to the soft switch to take effect.
Machine unable to wake up from
Sleep Mode (even after a firmware
upgrade).
Check/change the following soft switch setting:-
Sim 66-1 (Fax switch) SW92, Set bit 7 = 1.
The edge/ends of the fusing belt
become damaged.
This may be due to the fusing belt slipping towards the
rear frame side during rotation, especially when using
envelope mode.
Replace Fulcrum Plate F (Fuser Unit) with a modified
version. CPLTM8397FC01
Caution: Only install on machines manufactured up to
and including March 2011 production.
From April 2011, the Heat roller support frame has been
changed accordingly
UI becomes unresponsive when
selecting any icon from the HOME
screen (machine appears to hang)
Press and hold down the HOME key for approx. 5-10
seconds. If the counter window appears after a period
of time, the touch key operating setting maybe
changed. Via the MFP webpage, restore system
settings or check the following settings:-
Time for Accepting Key Entry: 0.0sec
Time for Accepting Key Entry of Long Touch: 0.4sec
Double Tap Interval Setting: 0.4sec
Please see administrator for
assistance (code pc) message on the
display, only after replacing the SCU
PWB from spare parts.
Check and ensure CN16 jumper is transferred from the
original to new SCU PWB.
USB Card reader not recognised
Change Sim 55-03, SW No.6 DATA No.8 from 0 to 1
Unable to setup or configure WiFi.
Wireless settings are not available
under Network Settings Menu.
To support the MX-EB13, install special ROM version
27.00.A1. After rebooting the MFP, enter SIM26-50
and enable WIRELESS SET (to ON).
To Next Page
Loading...
