After powering on the MFP device
(installed with DSK), it takes approx 8
minutes to come to a ready condition.
Check and/or replace the 1GB memory installed on the
MFP PWB.
Unable to activate Data Security Kit.
Once the Data Security Kit has been installed (as
described within the Installation Manual), the product
activation key can only be entered via the MFP
operation panel (and not via the MFP webpage).
Enter Settings - System Settings - Product Key menu
and input the unique activation key. Once registered,
power cycle the MFP device by using the primary
power switch (inside the front exterior cover).
After the MFP reboots, use Sim 22-10 to confirm the
DSK option is enabled.
When printing to a specific folder
without PIN, Error 421 occurs - only
when DSK is installed.
To print to a specific folder without PIN, perform the
following setting changes:-
1. Settings - Security Settings - Other Settings -
Disabling of Document Filing menu:- Un tick
Sharing Mode.
2. User Control - Authority Group List - Add Authority
group Registration - Job Setting - Security -
Document Filing Approval Setting menu:-
Enable Sharing Mode.
Under External Account control (OSA),
is it possible to lower the Automatic
Log Out (User) timer from 60
seconds?
Under User Control - Default Settings menu, enable
Automatic Logout Setting and change to the required
time (eg. 30 seconds).
Unable to enter the URLs for EAM
(External Accounting Mode) as the
item is missing from the webpage,
even though MXAMX3 is enabled.
Check the setting for Sim 26-03 (Coin Vendor Mode).
Ensure OUTSIDE AUDITOR is configured to None.
To Next Page
Loading...
