Note: Excludes Part Change/Correction Information.
Countermeasures to prevent noise from Right lower door unit, MF paper feed
unit and Right door unit.
Countermeasures against paper misalignment and paper jam when
discharging paper to the centre tray.
Measures to prevent noise from the Fusing drive unit.
Strength enhancement to prevent cracking of socket for Hinge R on the upper
cabinet rear.
Rom version upgrade (including revision history)
Countermeasures against power failure caused by defective L207 inductor on
the DC power supply PWB
Measures to prevent F1-31 trouble or FSDMJ paper jam in the saddle section.
Measures to prevent paper full detection error after removing paper jammed
in the delivery unit.
Measures to prevent the noise from RSPF transport sections.
Improvement to prevent noise when feeding high grade glossy paper.
Printer installation under Mac OSX 10.10
Specification change to support the new wireless standard in Australia
Countermeasure for creasing of paper when feeding A4R from the paper feed
cassette
Improvement of conductivity level between Fusing upper stay and Fusing rear
discharge brush.
Measures to prevent E7-11 trouble caused by faulty LED driver PWB.
Elimination of one way gear and Gear 19T/31T within the fusing unit.
Measures to prevent C4-00 error code.
Further improvement to prevent fusing belt damage.
Measures to prevent noise and/or POD1_N paper jam caused by the worn
fusing drive gear.
Measures against noise from PS clutch within RSPF unit.
Caution when replacing MC PWB to overcome the C1-14 trouble
Measures against toner smudge on the paper
Enhancement of the 2nd transfer belt frame to prevent pawl breakage
Removal of a fixing screw on DV side plate
Measures to prevent noise from the fusing drive unit.
Measures to prevent blank image caused by the DV belt B at the rear side of
the DV unit.
Further improvement to prevent fusing belt damage.
Caution when installing IC Card Reader
Measures to prevent noise caused by the transport follower roller.
Improvement to prevent noise from the paper feed reverse roller within the
paper feed unit.
Measures against PDPPD1_N paper jam caused by the deteriorated cushion.
Setup of new service parts - Saddle stapler
Enhancement of MF rotation pawl spring
Staple Unit & Staple Cartridge listing
To Next Page
Loading...
