Improvement to prevent folding misalignment due to paper skew within the
saddle section
Countermeasures against paper jam in tray 3/4 caused by low voltage output
of the desk control PWB
Firmware update for installation of MXFN10 & MXFN17 [revised February
2013]
MXRB10 paper pass unit upgrade
Changes in Sim43-1 and Sim55-1 SW18-1 to improve first copy out time
Measures to reduce the noise from RSPF unit, main drive unit and etc.
Countermeasure to prevent paper jam due to undetected paper passing the
PPD2 sensor
Further improvement to prevent the fusing belt from meandering
Device cloning from the operation panel
Reduction of noise from actuator movement on the RSPF transport or base
tray sections.
Elimination of Fusing Lower PG Pawls on Fusing Rear Upper PG
No power due to broken electronic circuit on DC power supply PWB
Change of main power LED indication
Elimination of the right adjuster
Fusing pressure spring enhancement
Lower web unit established as a service part
F2-64/65/66/67 Trouble code
Defective contact with SD card terminal
Service manual correction - Troubleshooting [Jam Code]
Improved cleaning performance of the cleaning blade within the process unit
Measures against the peeling of the fusing paper enter PG mylar
Measures to prevent fusing harness damage
Enhancement to prevent condensation inside the scanner unit
Scan to OSX10.7 using FTP
Enhancement to prevent fusing belt damage
Service manual correction - Maintenance [Fuser]
Change of tilt angle steps for the operation panel
C4-00 trouble due to misalignment of the TC PWB
Pressure release idle gear strength increase
Measures to prevent the follower roller end within the 1st transfer unit
becoming damaged
Measures to prevent the 2nd transfer belt damage
Measures to reduce the sound level of the actuator movement when
scanning originals through document feeder
Improvement of silence level inside the paper feed unit and the transport
drive unit
Measures to prevent the DV drive pulley in the main drive unit becoming
damaged
Abnormal noise from the right door unit
Measures to prevent POD1_N jams occurring, due to POD1 actuator
detection error
Change of DV cover to prevent toner splatter
To Next Page
Loading...
