MX-EB13 WIRELESS LAN SETUP
MX-EB13 Installation:
Before installation, be sure to turn both the operation and main power switches off and disconnect the
power plug from the power outlet.
1. Connect the MX-EB13 USB Wireless LAN adaptor to the rear side USB Port of the machine.
Note: Do not connect the USB adapter to the USB Port on the Operation Panel unit.
2. Power ON the MFP device.
3. Enter SIM26-50 and change [H. WIRELESS SET] from 0 to 1 to activate the Wireless LAN setting:-
4. Select OK and reboot the MFP Device.
To Next Page
Loading...
