Sharp MX-2614N

SHARP
IMAGE SEND COMMUNICATION ERROR
53
Report Code
(Result)
Result Displayed
Communication Interruption Content
0 - 31
Refer to “previous table”.
Depends on the point of communication interruption. For 16 or later, V.34
mode communication.
33
BUSY
The calling side cannot establish connection with the remote party.
34
CANCEL
A communication interruption command is made during sending/receiving.
The interruption key is pressed for interruption of input.
<Send/Receive/Polling/Bulletin board>
35
NG35 XXXX
Power is failed during sending/receiving. <Send/Receive/Polling/Bulletin
board>
36
No record paper
37
Record paper jam
38
MEM. FULL
Memory over during reception. <Receive/Polling>
Print is not made during reception in acting reception inhibit.
<Receive/Polling>
39
No. of paper unmatched
40
Relay not received
41
LENGTH OVER
The send data length of one page exceeds the limit (2m) in sending.
<Send/Bulletin board>
42
LENGTH OVER
The receive data length of one page exceeds the limit. <Receive/Polling>
43
Communication (OK)
Speaking before data transmission
44
ORIGINAL ERROR
A document jam occurs in direct sending. <Send>
45
Picture quality error
46
NO RESPONSE
The FAX signal from the remote party is not detected within T1 time.
<Send/Polling> (When in recall, however, the recall setting in case of a
communication error is valid.)
47
TX DECODE ERROR
A decode error occurs in the FAX board. <Send/Bulletin board>
48
OK
Normal end of communication
OK REPLY RECEIVE
OK in Internet FAX send with reception confirmation.
49
NO RX POLL
The called side does not have polling function in polling reception. <Polling>
The called side has no data to send. <Polling>
50
RX POLL FAIL
In polling reception, DCN is received for DTC. <Polling>
In polling sending, there is no send data. <Bulletin board>
51
PASS # NG
In poling sending, the allow number is not matched. <Bulletin board>
In polling sending, the system number is not matched. <Bulletin board>
52
No confidential function
in remote party
In confidential sending, the remote party does not have confidential function.
<Send> (Including other company's machines)
1) The NSF signal has not "Confidential function" bit.
2) The NSF is not a Sharp machine.
53
Confidential not received
In confidential sending, DCN is received for NSS. <Send>
54
Confidential BOX NO NG
In confidential reception, a confidential box number which is not registered is
specified.
55
No relay function in
remote party
In relay command sending, the remote machine has no relay function.
<Send> (Including other company's machine)
1) The NSF signal has not "Confidential function" bit.
2) The NSF is not a Sharp machine.
56
NO REL RX
1) In relay command sending, DCN is received for NSS. <Send>
2) In relay command reception, a remote station number which is not
registered is specified. <Receive>
3) In F code relay broadcasting, an F code relay command is
received.<Receive>
57
Relay ID unmatched
In relay command reception, the relay ID does not match. <Receive>